Cat Tree

Based on a photo found online.

  1. Calvin the Cat

  2. CatTree complete with Cat

  3. CatTree_smaller sized image

  4. simple finish on the doug fir veneer--several light coats of Danish oil covered with a thin layer of Johnson pastewax, hand buffed

  5. created a gasket seal for the door by applying a bead of silicone, spreading it out thin and even with a gloved finger.

  6. veneered cat tree halves - cutouts were laid out using a 14" radiused semi-circle template made from a scrap piece of 1/4" ply. Solid ash banding...

  7. Only one of six pieces resulted in grain tear out at the end of the bend. After the first three, I decided to create a backstrap using two strips of...

  8. Faux wool pad - sandwiched a spun poly cushion between faux fur and non-slip fabric with a couple strips of hook-and-loop for added security. I can...

  9. Cat Tree - the original picture that this project was based on. Cats not included in the actual build.

  10. Bought a new Timberwolf 3/4" 3tpi raker for resawing DougFir to make the veneers for the plywood frame halves.

  11. Found an advanced router tips video made by David Marks with information used to build this ellipse making jig. Lots of opportunities for refinement...

  12. Built the steamBox (right) and bending form (left) to create a 1-1/4" rim around the outside of each platform.
Showing photos 1 to 12 of 12