joe Katzenberger
03-27-2009, 11:03 PM
Good evening to all who are sliding down this slope
I am asking for advice on reading material on designing, laying out and cutting dovetail joints. I appreciate the videos, etc., resources but as an engineer I rather read the resource.
PS. Last week I could not respond to a fellow woodworker because I was late in renewing my contribution! The small contribution needed is a drop in the bucket to what you will benefit....advice, friendship, photos and the list goes on
I am asking for advice on reading material on designing, laying out and cutting dovetail joints. I appreciate the videos, etc., resources but as an engineer I rather read the resource.
PS. Last week I could not respond to a fellow woodworker because I was late in renewing my contribution! The small contribution needed is a drop in the bucket to what you will benefit....advice, friendship, photos and the list goes on