View Full Version : 60 Deg bevel on long board
10-04-2009, 7:52 PM
Maybe my brain is passing gas, but I need to cut a 60 degree back bevel (cleat)on an 8ft long board. Of course TS only tilts 45. Any suggestions.
10-04-2009, 7:56 PM
Cut a 30 degree on the other side of the board.
10-04-2009, 8:00 PM
How wide is the board? You could run it on edge with the TS set to 30.
10-04-2009, 8:02 PM
Its 5" wide.
10-04-2009, 8:16 PM
Got it Had to stand on side. Didn't feel 100% safe but worked out ok.
Powered by vBulletin® Version 4.2.2 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.