PDA

View Full Version : Where's Norm?



Mark Hulette
06-24-2003, 4:27 PM
The schedule on the NYW site says that he's supposed to be working today but not yet!

I wonder what will be next on the assembly table?

Norm's WebCam (http://www.newyankee.com/yankeecam.shtml)

Tom Sweeney
06-24-2003, 4:43 PM
The schedule on the NYW site says that he's supposed to be working today but not yet!

I wonder what will be next on the assembly table?

Norm's WebCam (http://www.newyankee.com/yankeecam.shtml)

looks like he's setting up a dovetail Jig & the guy is sitting next to the computer. A few camera & lighting guys popped in for a second also.

Sam Chambers
06-24-2003, 4:54 PM
Looks like he's yakking on the phone instead of making sawdust!

Ron Meadows
06-24-2003, 7:15 PM
You are a serious Norm follower huh? I went there one time.....not enough going on. One update a minute.....kinda like watching a very old movie that you could see every frame flicker by.

Jim Becker
06-24-2003, 7:35 PM
You are a serious Norm follower huh? I went there one time.....not enough going on. One update a minute.....kinda like watching a very old movie that you could see every frame flicker by.

I have it scripted so that I can just glance at it on days I'm not traveling. It gets interesting sometimes, but like any woodworking project and TV show taping, there is necessarily a lot of down time for mundane tasks. If you want to set it up that way, download this routine to your computer, unZIP it and bring it up on days when you want to watch.

http://sawsndust.com/downloads/NYW-webcam.zip

Mark Hulette
06-24-2003, 11:08 PM
You are a serious Norm follower huh? I went there one time.....not enough going on. One update a minute.....kinda like watching a very old movie that you could see every frame flicker by.


Well- when I popped in earlier, it was the same shot from the last session ( 2 clocks ). Just curious what's the next project.