View RSS Feed

Recent Blogs Posts

  1. Following through

    I had been too busy with work and then LOML's & my trip to Japan to make much progress on the taller table. With a long weekend it seemed time to finish up this project. The two tables were to be a "Family" but not identical. The smaller one, would be a little less refined and a bit "Bushido" looking. LOML refers to it as the samurai table.

    DSCN1276.jpg

    The taller one would be a bit more delicate and refined. I cut the prongs, and ...
    Categories
    Uncategorized
    Attached Thumbnails Attached Images
  2. Long anticipated Mini Glaser gloat/review

    Quote Originally Posted by Bill Wyko View Post
    Here is a size comparison. The wood handled tool is crown parting tool. it weighs 8.0 ounces. The Glaser weighs 1lb 1 ounce. over twice as heavy as the wood handled tool. This should translate into a little tool working like a big tool. Needless to say, I can't wait to get on the lathe. The handle is a little over 8-1/2 inches by itself. Overal length will vary slightly depending on the tool inserted in it.
    Categories
    Uncategorized