Originally Posted by Ole Anderson Can't go wrong with the flexibility of pegboard, make sure to get the 1/4" stuff, don't know if they even sell the 1/8" anymore. For the price of drywall, you can get 1/2" OSB which will take a beating compared to drywall and you can screw stuff to it without looking for studs. I have all three in my shop, even have OSB painted and unpainted. Either works fine. Pegboard on the bottom half wouldn't get my vote. Insulating the walls? = Ole, not sure what you recommend - did insulate ...
Before fastening on the top, I applied finish to everything - the cabinet, the shelves and the top. I rubbed on two coats of shellac, sanding with 220 grit lightly between each coat. Then I applied an oil/ urethane by hand, sanding with 220 between each coat. After the second coat of oil/urethane, I attached the top and applied the third coat. Once dry, I buffed the finish out with 0000 steel wool, installed the door knobs and hung the adjustable shelves. Here's the finished project. ...
Updated 01-28-2011 at 1:23 PM by Ben Arnott
Well, I was on the home stretch. I had the two doors to make, the shelves for the three bays, the top and finish left to do. I wanted inset doors with book matched straight panels to match the sides and to give the piece its Shaker inspiration. I followed the same preparation and construction practices as the sides, trying to be conscious of the grain pattern in the Cherry and Maple. After gluing up the doors, I cut the stiles to length and fit the doors by shimming them until I got ...
Updated 01-28-2011 at 9:56 AM by Ben Arnott
I sure miss being in the shop. I've been so busy with so many other things, I haven't set foot in the shop except to grab a tape measure or something for an outside job.
MC0U8502.jpg MC0U8505.jpg The two back panels and the two interior panels were made of sugar maple. The two back panels were made of 2 boards glued on edge and joined with biscuits. The two interior panels were made 3 boards glued on edge and joined with biscuits. The interior panels would separate the three bays. After the panels were glued up, I hand planed them across grain to flatten the boards out. Once flat, I planed with the grain to smooth ...
Updated 01-24-2011 at 4:22 PM by Ben Arnott