• Recent Polls

    How do you pronounce "fascia"? (Votes: 44)

    1. FAH-sya (Votes: 3)

    2. FAH-see-ya (Votes: 4)

    3. FAY-sya (Votes: 35)

    4. FAY-see-ya (Votes: 2)

    5. What the heck is a fascia? (Votes: 0)

  • Recent Forum Posts

    Andrew J. Coholic

    Biscuit Joiner

    We’ve had a genuine Lamello machine (well actually 4 of them) since the 80’s. Currently use a top 20 and zeta p2 in the shop.

    Andrew J. Coholic Today, 11:55 AM Go to last post
    Geoff Crimmins

    Carbide Bandsaw Blades

    That sounds like the same Jet bandsaw I have, and I'm not convinced that it can properly tension most carbide blades. If I was going to try it, I would

    Geoff Crimmins Today, 11:54 AM Go to last post
    Olaf Vogel

    DIY bowl turning lathe

    I'm also in the process of building a real bowl lathe. (although very different design)
    So have been doing a lot of research.

    One

    Olaf Vogel Today, 11:51 AM Go to last post
    Bill Adamsen

    Biscuit Joiner

    Building some custom drawers at 12-1/4" tall which required joining boards to get that height. I had planed down stock on hand and felt it would

    Bill Adamsen Today, 11:46 AM Go to last post
    Thom Sturgill

    Home made lathe

    wow! that should last a lifetime!

    Thom Sturgill Today, 11:43 AM Go to last post