Long legs for G0766

  1. Brice Rogers
    Brice Rogers
    I got my G0766 in Sept. 2015. One of the complaints by some was that the lathe spindle was too high. I am 5'9" and found the spindle too high. ( I actually ended up going to a chiropractor for back issues.)

    Around December of 2015 Griz changed the legs so that the spindle would be roughly 2 inches lower. Last year I received a pair of shorter legs. I swapped them out and now have a pair of the taller legs that are unused. So, if you are pretty tall and would like to have the spindle 2 inches higher, contact me by PM (i.e., send me a message).

    The legs could be used for a variety of other purposes but I'd rather see them go to another G0766 user.
  2. Roger Chandler
    Roger Chandler
    Hope you find a taker on those legs, Brice. A taller person could do well with them. I am 5' 11" and have the original legs. I put the feet on mine with both nuts on the upper side of the leg castings, and have a 3/4" rubber mat under my feet. I do not have to bend over to turn, which saves my back and neck, so mine is set up just right for me. I think my spindle height is about 46" now.
Results 1 to 2 of 2