• Kevin Stewart

    There is no available content written by Kevin Stewart
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Zach Dillinger

    Old wood bodied planes - parts source?

    Darn shame about that Ohio fillister... that would be a valuable plane if it were complete. Screw arm toted fillisters can bring a decent chunk of change.

    Zach Dillinger Today, 12:52 PM Go to last post
    Matt Day

    Input on this B&D Radial arm saw?

    Glad I could help! I would pass at anything over $150, based on the number of RAS's that are available in my area - yours may vary. Remember you'll likely

    Matt Day Today, 12:49 PM Go to last post
    Bill Brush

    Old wood bodied planes - parts source?

    My wife directed me to a gentleman she saw was selling some old wood bodied planes on FB. He wanted $50 for 3 planes and a wooden level, so I figured

    Bill Brush Today, 12:46 PM Go to last post
    Tai Fu

    Is the table saw (non sawstop) the most dangerous tool in the shop?

    Or you could get into a plane that crashes for whatever reason, be it snakes, missiles, weather, or UFO...

    Tai Fu Today, 12:45 PM Go to last post
    bruce buren

    My new kitchen

    Great cabinet work! I like the walnut accents! Also great documentation of the project step by step, nice to see the whole project start to finish.

    bruce buren Today, 12:44 PM Go to last post
  • Recent Blog Posts