• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Paul McGaha

    Official 2015 NFL Thread

    Thread Starter: Paul McGaha

    This will be a little different this year without a certain someone (KAB) complaining about how bad the Detroit Lions are (and bragging about how good the Michigan State Spartans are) but I thought I'd start a football thread for this year. My teams are the New Orleans Saints and the LSU Tigers...

    Last Post By: Chris Padilla Today, 1:01 PM Go to last post
    Patrick Chase

    Source for high-angle toothing plane?

    Thread Starter: Patrick Chase

    After Stewie's gentle prompting in another thread, I've gone off and read everything I could find on the topic, and realized that my exposure to toothing planes is grossly incomplete, limited as it is to toothed blades for low-angle BU planes. I'm therefore interested in acquiring a high-angle (80+...

    Last Post By: george wilson Today, 10:25 AM Go to last post
    Mike Henderson

    Hot Hide Glue Question

    Thread Starter: Mike Henderson

    When I do a project such as a chest of drawers, I usually use half blind dovetails to attach the bottom to the sides. I'm attempting to learn more about hot hide glue and want to do a project using it. Note the word "hot" for the hide glue. I'm not looking to use liquid hide glue, I want to use...

    Last Post By: paul cottingham Yesterday, 2:26 PM Go to last post
    Stanley Covington

    Toolchest Lid-Mounted Tools

    Thread Starter: Stanley Covington

    Sawmill Creek is flowing sluggishly under the ice today, so I thought I would post something. Some of you may recall my mentioning in a post a year or so ago that I was reworking the methods of mounting tools inside the lid of my old toolchest. My day job has kept me very busy since then, but I...

    Last Post By: Stanley Covington Today, 3:22 AM Go to last post
    Ed Gibbons

    Ouch--Getting Saw Stop

    Thread Starter: Ed Gibbons

    Spent some time in the ER and ended up seeing a hand surgeon. Just nicked the tip of my finger. Didn't look pretty but prognosis is good. Surgeon said that most table saw injuries happen after years of operation. Rookies are more focused but experienced woodworkers become too comfortable. I fit...

    Last Post By: mreza Salav Today, 12:49 PM Go to last post
    Edward Weingarden

    New Sander

    Thread Starter: Edward Weingarden

    My angle sander just died so I'm looking for a new one. The decisions include air powered ROS vs electric, and non-ROS vs ROS. Question #2 is...if I use air powered, what size compressor is appropriate? Thanks.

    Last Post By: George Overpeck Yesterday, 4:15 PM Go to last post
  • mike johnston

    There is no available content written by mike johnston