• Rod Sheridan

    There is no available content written by Rod Sheridan
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Paulh Tremblay

    Jessem doweling jig, flat work adapter

    To add to what Bill Huber (the chief expert on doweling!) said. Say you measure down 16 7/16 by mistake. Your dowel pins would still match perfectly.

    Paulh Tremblay Today, 11:01 PM Go to last post
    James Tibbetts

    Fence to keep rabbits out?

    Same answer as the squirrel repellant thread.... battered, pan fried.

    James Tibbetts Today, 10:55 PM Go to last post
    Lee Schierer

    Kitchen Pantry microwave broom closet

    Correction: The Transformations product is made by Rustoleum not Minwax. Sorry for the confusion.

    Lee Schierer Today, 10:55 PM Go to last post
    Lee Schierer

    Rusty iron

    You can buff the surfaces with a scotchbrite pad in a vibratory sander. Put some light oil on the surface as a lubricant. It makes a mess, but it will

    Lee Schierer Today, 10:50 PM Go to last post
    Lee Schierer

    3/16" Dado Burning Red Oak

    Yes, but is the blade perfectly aligned with the miter slots? I've cut grooves with my Freud crosscut blades on occasion in red oak with no problems.

    Lee Schierer Today, 10:47 PM Go to last post
  • Recent Blog Posts