Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Mike King Today, 10:32 AMI need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...
Last Post By: Geoff Crimmins Today, 12:08 PMhas anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...
Last Post By: Maurice Mcmurry Today, 5:00 PMHere's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...
Last Post By: Rich Engelhardt Today, 4:07 PMThis morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...
Last Post By: Tom M King Today, 5:17 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
I was at an estate sale today and they had this Stanley Bailey #7 Made in England plane. From what I can tell the Made in England plans are not considered
Bob Vavricka Today, 6:19 PMI'll send the points out tomorrow. I should still have your address in my PM's.
You pull that loop up, drop the points in, and put the spring
Tom I purchase that tool, thanks for providing that link and help
Carroll Courtney Today, 6:04 PMI'm not sure why you'd need a locking miter for that. This is long grain adhesion...it will be insanely strong, even for a short lamp.
Michael Burnside Today, 6:00 PMTitle says it all, looking for a used Tornek T-8 in good shape. Located in Indiana, will pay via PayPal.
Matt Day Today, 5:59 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Bert Kemp Yesterday, 8:28 PM