• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Roger Chandler

    G0766 22 X 42 lathe - Ordered!

    Thread Starter: Roger Chandler

    Well, just as a follow up to the other thread......I just pulled the trigger on the new G0766 :o:D Not trying to be the first or anything like that, but feel like this will serve me well for years to come, and is likely the best value in a large lathe on the market today. While one can see it...

    Last Post By: Roger Chandler Yesterday, 8:22 PM Go to last post
    Roger Chandler

    New model- G0766 [Upgrade possible!]

    Thread Starter: Roger Chandler

    Well.........my 2015 Grizzly catalog arrived today........been looking forward to getting it, because, for a few weeks, without any specific knowledge about it, I just had this inner feeling that there might be a new lathe model this year.........nah, maybe just a thought, but wait maybe that...

    Last Post By: Roger Chandler Yesterday, 8:24 PM Go to last post
    Mike Heidrick

    Pole Barn 40X64X16

    Thread Starter: Mike Heidrick

    Signed a contract yesterday with S&L Builders out of Indiana for a 40X64X16 Pole Barn with a 10X24 porch. Build date August 18, 2014. Plan to install Pex for raidant floor heat. Concrete slab 5" thick. Also doing 1.5" closed cell foam under the pad. Built on Laminated posts in ground. Will...

    Last Post By: Mike Heidrick Today, 2:20 AM Go to last post
    Karl Fife

    Close-Up and Personal Look at the NEW Lie-Nielsen Stainless Steel Honing Guide.

    Thread Starter: Karl Fife

    I just returned from the Lie Nielsen Hand tool event in Chicago. While I was there, I saw the much anticipated Lie Nielsen Stainless honing guide. I took some pictures which I have shared below. Some of this you've seen, other details perhaps not. Noteworthy observations: 1. It appears...

    Last Post By: Greg Husband Yesterday, 10:42 AM Go to last post
    Prashun Patel

    Slab desk build

    Thread Starter: Prashun Patel

    I'm making a slab desk for a friend. The desk will be 60" long x 30" wide. There's nothing sophisticated about this design, but it's going to be fun, so I thought I'd share my process. I purchased these 120"x21" walnut slabs from Horizon Lumber. perhaps all mills do this, but Pete takes...

    Last Post By: Prashun Patel Yesterday, 4:55 PM Go to last post
    Marty Tippin

    SawStop Sliding Crosscut Table

    Thread Starter: Marty Tippin

    I was looking at the SawStop at the local Woodcraft over the weekend and they had it set up with the SawStop sliding crosscut table attachment. http://www.sawstop.com/crosscut I pretty much fell in love with it and believe I'll have to include it when I buy my SawStop in the next few months....

    Last Post By: Jim Kirkpatrick Yesterday, 7:27 PM Go to last post
  • Dennis McDonaugh

    There is no available content written by Dennis McDonaugh