• Will Overton

    There is no available content written by Will Overton
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    don wilwol

    Jonesing

    I love hunting for old tools. For my wife and I, its become our vacations. But Handymans? I've decided from now on, any $2 hanyman I find, I'll pay for

    don wilwol Today, 6:24 AM Go to last post
    John Lanciani

    Window Framing Question

    Top. Set all of your headers at the same height.

    John Lanciani Today, 6:03 AM Go to last post
    Max Neu

    Bottom Bearing 1/8" Roundover Router Bit that projects less than 1/2"

    Typically I use a shaper for stuff like that, but occasionally I use the bench cookies if I just have a small piece to do, and feel to lazy to set up

    Max Neu Today, 5:41 AM Go to last post
    Brent Ramsay-Boyd

    Faulty Tube, could I have done something wrong.

    Thanks for you feedback, I must have just been the unlucky recipient of a faulty tube. Other than a bit of frustration, it is not too bad, and they are

    Brent Ramsay-Boyd Today, 5:03 AM Go to last post
    Gabriel Voicu

    40W tube on 60W power supply?

    Thank you, everyone for your answers.
    I intended to install a smaller tube without any modifications. I found a supplier around here that said they

    Gabriel Voicu Today, 4:47 AM Go to last post
  • Recent Blog Posts