• Leigh Betsch

    There is no available content written by Leigh Betsch
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    David Kumm

    Bandsaw Tension Guage

    I found the same thing Joe. I have several saws and different blades and each has a little different sweet spot. There is a trick- like anything else

    David Kumm Today, 10:42 AM Go to last post
    john zulu

    Favorite planes - shifting loyalties

    Hmmm loyalty...... I was a stricter hand tools guy until I met some wood working condition which hand tools just don't cut it....... For example parquet

    john zulu Today, 10:40 AM Go to last post
    Peter Quinn

    Safest way to cut maple counter top

    Is the inlay curved or straight? This is not clear, my approach would vary considerably depending on thAt factor and shape of counter at edges.

    Peter Quinn Today, 10:36 AM Go to last post
    Joe Jensen

    Bandsaw Tension Guage

    I've been an avid WW for over 35 years and I've owned good bandsaws for over 25 years. My current bandsaw is a Felder FB540 made by ACM of Italy. I've

    Joe Jensen Today, 10:35 AM Go to last post
    Grant Wilkinson

    3M Airstream System

    I think that Steve has your solution, Dave. When I was still using 3M batteries, I had to sand off a bit on the male plugs to get them to plug in easily.

    Grant Wilkinson Today, 10:34 AM Go to last post
  • Recent Blog Posts