• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Jerome Stanek

    Glowforge release

    Thread Starter: Jerome Stanek

    I was wondering if Glowforge has sent out any units yet. I thought they were supposed to release the middle of December.

    Last Post By: Dave Sheldrake Yesterday, 10:41 PM Go to last post
    Mike Heidrick

    Pole Barn 40X64X16

    Thread Starter: Mike Heidrick

    Signed a contract yesterday with S&L Builders out of Indiana for a 40X64X16 Pole Barn with a 10X24 porch. Build date August 18, 2014. Plan to install Pex for raidant floor heat. Concrete slab 5" thick. Also doing 1.5" closed cell foam under the pad. Built on Laminated posts in ground. Will...

    Last Post By: Larry Frank Yesterday, 8:30 AM Go to last post
    Normand Leblanc

    Getting ready for the winter: Sharpening your ice scraper.

    Thread Starter: Normand Leblanc

    This post is for anyone living in cold climate and, whoever do not have to deal with snow and ice, see next post and please do not give your opinion on something you don't know. It's pretty technical so we'll keep this discussion for those concerned. For this difficult sharpening, I propose the...

    Last Post By: Ole Anderson Yesterday, 9:57 AM Go to last post
    Todd Mason-Darnell

    Sawstop accidental safety trip

    Thread Starter: Todd Mason-Darnell

    Well, I joined the idiot club. I accidently set off the brake on the Sawstop today. I was sneaking up on the cut for a rabbet cut and was using my combo square to help adjust the height of the blade. Of course, I was in a hurry and brought the METAL square over before the blade had come to a...

    Last Post By: Roger Feeley Yesterday, 5:22 PM Go to last post
    Bert Kemp

    Tire air Pressure

    Thread Starter: Bert Kemp

    I was going to bring this up in the oil check thread but decided to start a new one for what I think is far more critical then checking oil and thats checking your tires air pressure. Its more troublesome to check 4 tires for air but way more important from a safety point. I think low air pressure...

    Last Post By: Curt Harms Yesterday, 8:14 AM Go to last post
    Martin Wasner

    My new shop

    Thread Starter: Martin Wasner

    I've been in business 12 years. My first shop was 1600 sq/ft, I occupied it for almost six years. The current shop is 2500 sq/ft. As of a few days ago, I've been in here six years. When I first moved into the current space, I thought it would take a long time to fill it up. Turns out it only...

    Last Post By: Frederick Skelly Yesterday, 10:25 PM Go to last post
  • Deane Allinson

    There is no available content written by Deane Allinson