• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Mike Heidrick

    Pole Barn 40X64X16

    Thread Starter: Mike Heidrick

    Signed a contract yesterday with S&L Builders out of Indiana for a 40X64X16 Pole Barn with a 10X24 porch. Build date August 18, 2014. Plan to install Pex for raidant floor heat. Concrete slab 5" thick. Also doing 1.5" closed cell foam under the pad. Built on Laminated posts in ground. Will...

    Last Post By: Ken Grant Yesterday, 2:19 PM Go to last post
    Simon MacGowen

    Is posting videos on youtube showing second-rate skills or results fine with you?

    Thread Starter: Simon MacGowen

    I have come across quite a number of "tutorial" videos on youtube with good intentions, trying to share hand tool techniques with everyone, that are in my opinion below the fine woodworking quality. The most common examples are those showing the finished joints with tiny or unsightly gaps,...

    Last Post By: Steve Tripp Yesterday, 10:19 PM Go to last post
    mark mcfarlane

    Yet another shop build.... McFarlane

    Thread Starter: mark mcfarlane

    After a 9 month battle with the local water district over an easement, we started clearing the land for my new shop today. It was amazing to watch these guys clear the land. We had three 80-100' pine trees removed and about a dozen smaller ones. One of the tall trees was 2 feet off my...

    Last Post By: Jim Becker Yesterday, 10:04 AM Go to last post
    Mike O'Melia

    Chainsaw Thoughts?

    Thread Starter: Mike O'Melia

    My old Poulan 18" has seen better days. I could definitely use something with a longer bar. Any body have thoughts on a good consumer/residential chainsaw? (bigger than 18") Mike

    Last Post By: Bernie May Today, 7:42 AM Go to last post
    steven c newman

    They're baaack

    Thread Starter: steven c newman

    Stopped in at Aldi's Friday.. $6.99 + sales tax... Haven't taken these out of the package, yet.... Bought a set about 2 years or so ago.....still going strong. My current users. If I get a bit of time, I may tune the new ones up. Might even post a few pictures....

    Last Post By: Patrick Chase Yesterday, 9:57 PM Go to last post
    jack dempsey

    Tablesaw Crosscut sled

    Thread Starter: jack dempsey

    Hello, I am preparing to make a tablesaw crosscut sled. I am not sure what material to use for the runners. I would like advice/opinions on using the steel runners like the ones sold by Incra as opposed to using hardwood for the runners. If you have made these sleds I would like your insight....

    Last Post By: Bert McMahan Yesterday, 6:56 PM Go to last post
  • Jason Roehl

    There is no available content written by Jason Roehl