:D Just got word from CS @ Grizzly that the G0766 lathes have left the factory and are in fact "en route" and the expected delivery date for my unit is now ......get this, a week earlier May 15th! :) Now, I know there are some others who were expecting to have it shipped on May 22nd as...Last Post By: Roger Chandler Today, 2:37 PM
Welp. It finally happened. Sometime last year I began to hear a noise in the motor of my Jet EVS 1642. Of course it was just out of warranty. I bought it May of 2009 and started realizing the noise sometime last fall or so... Well Saturday I was in the shop turning some coffee table legs and the...Last Post By: george wilson Today, 5:20 PM
So I took my 5.5 and was going to see what I could figure out in reference to the recently found video of a cap iron's placement and how if affects ( prevents ) tear out in any direction.... I got the blade super close to the edge, almost to the point that a magnification was needed to make sure it...Last Post By: John A. Callaway Today, 11:16 AM
Is a turntable a musical instrument? :rolleyes: Maybe... :) Somehow I got myself into another project, bringing an old Dual 1229, I bought in 1972, back to working order.The fix was replacing a couple of small parts and then cleaning and lubricating. The grease tends to goop up over the years. ...Last Post By: Julie Moriarty Today, 4:07 PM
The Wikipedia article isnít. Is there some open woodworking wiki that would be suitable? If not, here? Just got my copy of Virtuoso....Last Post By: Mark Stutz Today, 10:18 PM
Veritas 50" Aluminum StraightEdge (acc. w/in .003) (Votes: 16)
Veritas 36" Steel StraightEdge (acc. w/in .0015) (Votes: 11)
God Bless the citizens of Margraten, Netherlands. Remarkable.