• Mark Singer

    There is no available content written by Mark Singer
  • Recent Polls

    What kind of tool user are you? (Votes: 166)

    1. All power tools (Votes: 6)

    2. Mostly power tools (Votes: 52)

    3. A mix of power & hand tools (Votes: 79)

    4. Mostly hand tools (Votes: 26)

    5. All hand tools (Votes: 3)

  • Recent Forum Posts

    Kyle Iwamoto

    When do you give up on a turning?

    I almost never give up. Yep I'm stubborn. BUT I'm careful. I rough with my cage down, and several times have been saved by the cage. I have had pieces

    Kyle Iwamoto Today, 3:28 AM Go to last post
    jack forsberg

    Shaper cutters

    Very good Point Mel that without blanks the Gibbs can distort and damage the corrugation in the block . My only comment would be is that the projection

    jack forsberg Today, 3:25 AM Go to last post
    robert baccus

    When do you give up on a turning?

    Good for you! We all have spasms of stupidity on an attractive piece of flotsom now and then and spend hours and anguish on them. THought--go buy a

    robert baccus Today, 2:01 AM Go to last post
    Mack Gambrell

    Mobility for Nova 1624 II Lathes

    I got the 2445T12 drilled and tapped the legs to 1/2"
    Each caster good for 300lbs.
    They are perfect for me I don't plan on moving it

    Mack Gambrell Today, 1:52 AM Go to last post
    mark morgan

    New Garage/Shop

    Started working on the soffits, didn't get too far it was over 100 degrees today. I also seem to have a wasp problem which is making working on a ladder

    mark morgan Today, 1:28 AM Go to last post
  • Recent Blog Posts