• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dan Hintz

    DIY air filtration unit for <$200

    Thread Starter: Dan Hintz

    As payback to the lasering community, I'm sharing my "plans" (such as they are) for everyone to copy. Well, not so much "plans" as pictures of the completed unit, but it should be obvious how to recreate something similar. Due to poor planning on my part and a lack of any real sleep, I made one...

    Last Post By: Glen Monaghan Yesterday, 7:05 PM Go to last post
    Jerome Stanek

    Glowforge release

    Thread Starter: Jerome Stanek

    I was wondering if Glowforge has sent out any units yet. I thought they were supposed to release the middle of December.

    Last Post By: Rich Harman Today, 6:19 PM Go to last post
    Patrick Chase

    Clearance in BD plane

    Thread Starter: Patrick Chase

    I finally managed to have an honest-to-goodness clearance issue. I've been playing with low-angle frogs in a couple of my smoothers, and had a 40-deg one in my LV custom 4-1/2 last week. I swapped a new blade in while working some Red Alder with a medium cut (several mils, I didn't measure), and...

    Last Post By: bridger berdel Today, 4:10 PM Go to last post
    Rick Fisher

    Building dream shop, need clever ideas

    Thread Starter: Rick Fisher

    Hello. We recently sold our house and are building a new one. As part of this, I am able to build my own woodworking shop. The zoning on the lot only allows for 985sf. So .. I'm building the shop 985 sf. I want as few regrets as possible. So far, this is what I've arranged. ...

    Last Post By: John K Jordan Today, 2:14 PM Go to last post
    Mike Cherry

    White Oak Trestle Desk Journal

    Thread Starter: Mike Cherry

    The wife is retiring after 20 years in the US Marine Corps. She has requested a desk and I found a design that we both agreed on. She chose white oak because she is from Thousand Oaks, CA. I didnt argue at first because I have seldom used white oak and it seems like a good challenge. After...

    Last Post By: Mike Cherry Today, 6:25 PM Go to last post
    Bob Glenn

    Junk, junk, junk

    Thread Starter: Bob Glenn

    Years ago I bought a cheap 8 inch Delta miter saw. Some years later, the trigger switch quit working. So I decided to upgrade and bought a Hitachi 10 inch miter saw. Recently, the trigger switch has been acting up. Today, the saw would not stop when the trigger was released. I finally got the...

    Last Post By: Glenn de Souza Yesterday, 10:08 PM Go to last post
  • Bob Strawn

    There is no available content written by Bob Strawn