• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Walsh

    Woodpeckers drill press table..

    Thread Starter: Patrick Walsh

    I purchasd one in a pinch today. I went to Woodcraft to gather the parts needed to make my own. After some himming and howing a very nice sales rep pointed out Woodpeckers had one fully made right over here. This sounded like the move as i realy have no interest nor the time to make one. Well it...

    Last Post By: Mark Carlson Yesterday, 2:34 PM Go to last post
    Dan Letkeman

    Grizzly planer and jointer spiral cutter head bolts

    Thread Starter: Dan Letkeman

    Hello, Wondering if anyone else has rotated there spiral cutter heads and broke the torx bolts? I would like to order replacement bolts, but I am unable to find them from any other place than grizzly. I would prefer not to order them from grizzly at $1/bolt, as I would like to have enouph...

    Last Post By: Cary Falk Yesterday, 10:27 AM Go to last post
    Jim Koepke

    Old Molding Planes and the Rehab Enthusiast

    Thread Starter: Jim Koepke

    As is often the case with metal planes, when a wooden body molding plane enters the shop, it is usually in need of some TLC before going to work. Some have expressed interest in knowing more about the process of bringing an old molding plane back to a usable state. I am just a beginner when it...

    Last Post By: Frederick Skelly Yesterday, 9:10 PM Go to last post
    Alan Schaffter

    New Woodworking Bench (Parts I & II of II)

    Thread Starter: Alan Schaffter

    Way back in Sept '07 after completing new extension and outfeed tables for my tablesaw, I said that my next project was going to be a relatively traditional woodworking bench based on a design by Lon Schleining which was first published in FWW a few years ago (see the copy on my extension table) ....

    Last Post By: William Fretwell Today, 12:10 AM Go to last post
    Kris Cook

    Traditional European Workbench Build

    Thread Starter: Kris Cook

    Hello - I joined the site yesterday and posted in the general forum. I thought I would post pictures of my workbench project here. I have been wanting a good workbench for many years. I finally have the tools and space to get it done. We shall see about the time component. I was working out...

    Last Post By: Robert Engel Today, 8:55 AM Go to last post
    Kyle Kaldor

    Grizzly GO691 Motor Issues

    Thread Starter: Kyle Kaldor

    Today after ripping through 6 sheets of 3/4" plywood for cabinets, my Grizzly GO691 table saw motor is having some issues. I started it up to make my last cut, and it turned very slow and made some weird noises. I would describe the noise as a slight grinding, bogged down noise. I would say the...

    Last Post By: CPeter James Yesterday, 9:18 PM Go to last post
  • Steve Grazier

    There is no available content written by Steve Grazier