• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    george wilson

    Why don't you use ceramic stones?

    Thread Starter: george wilson

    Maybe I got lucky. My flattening of the White stone took about an hour,using a used diamond stone. It was slightly out of flat,and had a fuzzy spot of ceramic that had to go. I have seen pictures of "sawn" looking ceramic stones by Spyderco(my brand),but haven't encountered one personally. I got...

    Last Post By: george wilson Yesterday, 1:41 PM Go to last post
    Karl Fife

    Close-Up and Personal Look at the NEW Lie-Nielsen PLOW PLANE

    Thread Starter: Karl Fife

    Here are a few pictures I took of the much-anticipated Lie Nielsen Plow Plane (Plough Plane) while at Handworks 2015 in Amana, Iowa. Apparently I can only put 8 pictures in a post, so I'll reply to my own post with four more. As you know, this tool is based on the Miller's...

    Last Post By: Karl Fife Today, 3:06 AM Go to last post
    Tom Clark FL

    Shop Cabinets

    Thread Starter: Tom Clark FL

    Home workshops are the place where dreams are made. We all love our shops, and the time we get to spend in themů Thirty years ago I built my first wood shop, and while filling it up soon learned that a lot of storage was necessary. And one of the best parts of being a woodworker is building out...

    Last Post By: Ron Walker Today, 7:47 AM Go to last post
    lowell holmes

    Did you build one?

    Thread Starter: lowell holmes

    A saw bench that is. I did, it looks a lot like this one. I would not be without it.

    Last Post By: Thomas Schneider Yesterday, 11:10 PM Go to last post
    Aaron Craven

    Buffing questions

    Thread Starter: Aaron Craven

    I've had a few bowls recently that didn't have quite the sheen I wanted (primarily on oil finishes), so I've decided to pick up some buffing equipment. I'm not a big fan of wax for most items, so I'll probably skip the carnauba step (though I'm buying all three wheels in case I change my mind). I...

    Last Post By: Marvin Hasenak Today, 12:27 AM Go to last post
    Susumu Mori

    Raised panel cutter for shaper

    Thread Starter: Susumu Mori

    Hi all, I have a shaper but for raised panels, I'm still using a router bit (3.5 inch). It runs and cuts fine with a 1/2 inch coupler and at 10,000 rpm. The shaper runs much quieter and smoother. So, I like it but it needs many passes (6-7 passes). I guess my question is, do you think it's...

    Last Post By: Martin Wasner Today, 9:16 AM Go to last post
  • Terry Beadle

    There is no available content written by Terry Beadle