• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Ed Gibbons

    Ouch--Getting Saw Stop

    Thread Starter: Ed Gibbons

    Spent some time in the ER and ended up seeing a hand surgeon. Just nicked the tip of my finger. Didn't look pretty but prognosis is good. Surgeon said that most table saw injuries happen after years of operation. Rookies are more focused but experienced woodworkers become too comfortable. I fit...

    Last Post By: Patrick Curry Yesterday, 9:46 PM Go to last post
    Lasse Hilbrandt

    Which smoothing plane

    Thread Starter: Lasse Hilbrandt

    I know this must be a topic which has been discussed to death over and over again. Nevertheless I need some piece of advise on which smoothing plane to buy. I have Stanley no 7, a LN no 5, and Stanley no. 4. Im not really using the Stanley 4. I find it a bit bulky. I think I need an alround...

    Last Post By: Mike Holbrook Today, 12:30 AM Go to last post
    Allen Bookout

    Are these wood prices out of line?

    Thread Starter: Allen Bookout

    I need to find a place to buy good wood. I live about twenty miles north of Fort Myers Florida and Alva Hardwoods east of Fort Myers is about the only supplier around here that I know of. I would think that there would be some suppliers in the Tampa area but if these prices are reasonable I would...

    Last Post By: Julie Moriarty Today, 12:44 PM Go to last post
    Brian Holcombe

    Medicine Cabinets - Build thread

    Thread Starter: Brian Holcombe

    Evening! Building a pair of medicine cabinets for my house to replace some real junkers installed by the original builder. These will set into the wall and reveal about 2" of the cabinet. This first cabinet is the prototype, so there will be limited photos of the process, but the second one...

    Last Post By: Brian Holcombe Today, 12:17 AM Go to last post
    Roger Chandler

    G0766 - Sounds

    Thread Starter: Roger Chandler

    On one of the other threads I read last night and this morning, there were questions regarding the "sounds" or "noises" that come from the new G0766. I began my third project this morning since receiving my unit. This mornings project was the biggest blank I have put on the lathe so far, and...

    Last Post By: Roger Chandler Yesterday, 8:00 PM Go to last post
    Terry Thillemann

    Impact driver for cabinet building

    Thread Starter: Terry Thillemann

    What's a good impact driver for building cabinets, assembling workbenches, etc.? I had my eye on the Dewalt dcf895d2 but am going to buy the Festool 150/5 and vacuum soon so I was wondering how the Festool driver stacked up. The Festool comparison video I found on YouTube was fairly old so I'm...

    Last Post By: Martin Wasner Today, 9:49 AM Go to last post
  • Frank Pellow

    There is no available content written by Frank Pellow