• Carl L Goff

    There is no available content written by Carl L Goff
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Robert Hazelwood

    Is it wrong...

    I don't really think it's bad to use the diamond stones for both purposes...as long as you don't use too much pressure when grinding the primary bevel

    Robert Hazelwood Today, 8:57 AM Go to last post
    ian maybury

    Work Sharp 3000/diamond discs/establishing chisel surfaces...

    I'll give the MDF a run David - and try some hard leather as well. What you say about taking care to preserve geometry is where my gut tends to lead me

    ian maybury Today, 8:56 AM Go to last post
    David Weaver

    Quina--Argentine Sandalwood--what is it good for?

    Japan woodworker's listings have a habit of describing anything's "well, of course" virtues as being something special. Of course the wrought

    David Weaver Today, 8:54 AM Go to last post
    lowell holmes

    drunken purchase

    One of my Narex pig stickers is a 1/8" chisel. I don't know why, I just needed it.

    lowell holmes Today, 8:54 AM Go to last post
    Prashun Patel

    Proper finish over dewaxed shellac

    If it were me, I'd use a poly. I think it only starts to look plasticky when built into a substantial film. I'd use a satin or semigloss and I'd wipe

    Prashun Patel Today, 8:53 AM Go to last post
  • Recent Blog Posts