• Gary Kvasnicka

    There is no available content written by Gary Kvasnicka
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Brent Ramsay-Boyd

    Bubbles in My Laser tube

    Hi Walter

    I have tried that. They seem to be pretty stubbornly stuck. I read somewhere that antifreeze may help. Do you know if it is good

    Brent Ramsay-Boyd Today, 6:31 AM Go to last post
    Rich Harman

    need desperate help aligning gweike laser engraver/cutter

    It is possible, even probable that your laser head, the assembly that holds the third mirror and your lens, is not exactly perpendicular to the table.

    Rich Harman Today, 6:24 AM Go to last post
    Lee Roberts

    Is the table saw (non sawstop) the most dangerous tool in the shop?

    You're joking about the SS preventing kickback, right?

    The three 'more than minor' injuries I've sustained in my shop:

    Worst:

    Lee Roberts Today, 6:23 AM Go to last post
    William Adams

    Is it time for a Mac?

    That's one of the things which I really mis-like about Mac OS X --- NeXT/OPENstep ran well on 33MHz 68040 processors (okay on the 25MHz board I had in

    William Adams Today, 6:10 AM Go to last post
    walter hofmann

    Bubbles in My Laser tube

    hi brent
    no there is nothing what you could add the only way to get the bubbles out a necessity is to loosen the tube holder and lift the tube careful

    walter hofmann Today, 5:37 AM Go to last post
  • Recent Blog Posts