• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Chase

    Source for high-angle toothing plane?

    Thread Starter: Patrick Chase

    After Stewie's gentle prompting in another thread, I've gone off and read everything I could find on the topic, and realized that my exposure to toothing planes is grossly incomplete, limited as it is to toothed blades for low-angle BU planes. I'm therefore interested in acquiring a high-angle (80+...

    Last Post By: Steve Voigt Today, 1:26 PM Go to last post
    Keith Outten

    FreeStuff Drawing - Premium Woodturning Set

    Thread Starter: Keith Outten

    FreeStuff Drawing from Carter and Son Toolworks The name of the winner of this drawing will be announced on February 11th, 2016 Premium Woodturning Set Includes: 5/8" Bowl gouge: Incredibly strong and sharp, our 5/8" Bowl Gouge offers an enhanced bowl turning experience. Made of M42...

    Last Post By: Mike Cooper Today, 6:03 PM Go to last post
    Edward Weingarden

    New Sander

    Thread Starter: Edward Weingarden

    My angle sander just died so I'm looking for a new one. The decisions include air powered ROS vs electric, and non-ROS vs ROS. Question #2 is...if I use air powered, what size compressor is appropriate? Thanks.

    Last Post By: Olaf Vogel Yesterday, 8:18 PM Go to last post
    Stew Hagerty

    Veritas Shooting Plane Tolerance

    Thread Starter: Stew Hagerty

    Hey all... It's been quite a while since I posted. The last year or so hasn't been great. Anyway, that has absolutely nothing to do with this post. A couple years ago out in Iowa at Handworks I so a thing of beauty. It was the plastic prototype for a Veritas Shooting Plane. Now the Stanley...

    Last Post By: Patrick Chase Yesterday, 8:16 PM Go to last post
    Allen Bookout

    Are these wood prices out of line?

    Thread Starter: Allen Bookout

    I need to find a place to buy good wood. I live about twenty miles north of Fort Myers Florida and Alva Hardwoods east of Fort Myers is about the only supplier around here that I know of. I would think that there would be some suppliers in the Tampa area but if these prices are reasonable I would...

    Last Post By: Steve Kinnaird Today, 12:01 AM Go to last post
    Ed Gibbons

    Ouch--Getting Saw Stop

    Thread Starter: Ed Gibbons

    Spent some time in the ER and ended up seeing a hand surgeon. Just nicked the tip of my finger. Didn't look pretty but prognosis is good. Surgeon said that most table saw injuries happen after years of operation. Rookies are more focused but experienced woodworkers become too comfortable. I fit...

    Last Post By: Chris Padilla Today, 6:03 PM Go to last post
  • Dan Hintz

    There is no available content written by Dan Hintz