• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Kent A Bathurst

    Official 2015 MLB Thread

    Thread Starter: Kent A Bathurst

    Verlander is on the DL. Nathan is also. Porcello with the BoSox. Both Fister and Scherzer throwing for the Senators. That is the closer and 4 starters from 2 years ago; closer and 2 Cy Young starters from last year. What's that mean? Detroit is 8-1 - best record in MLB. Only one run off...

    Last Post By: Kent A Bathurst Yesterday, 7:12 PM Go to last post
    Brian Holcombe

    Cabinet build

    Thread Starter: Brian Holcombe

    Hello Walnut! ....Never again! Not flat

    Last Post By: Brian Holcombe Today, 1:28 PM Go to last post
    Eduard Nemirovsky

    Swimming Pool or No pool?

    Thread Starter: Eduard Nemirovsky

    I have a small pond in my backyard - about 12 by 8. We put it on about 8-9 years ago. I am ready to fill it in with dirt - so tired to take care of it. Question arise - should we put a pool on this place? Thinking about fiberglass vs concrete, medium size. Owners of the pool - please chimes with...

    Last Post By: Chris Padilla Yesterday, 5:43 PM Go to last post
    Mike Holbrook

    A better wedge

    Thread Starter: Mike Holbrook

    I was attempting to split a 8x25" white oak log with a friend last week. The L&N froe was not enough. Most wedges lack the bevel needed to penetrate wood like this. I have sen wedges used by guys like Curtis Buchanan that are longer and wider than the average wedge available today. The bevel on the...

    Last Post By: David Ragan Today, 1:24 PM Go to last post
    Jim Gunter

    Possible Shark 3D CNC Router

    Thread Starter: Jim Gunter

    Hello CNC community. I am a home hobby wood worker and have been making furniture from Oak rough boards for some time now. Mostly for home and the kids. Bedroom sets kitchen cabinets, living room furniture etc. I plan to retire from my paying job in a couple years and thought about adding CNC...

    Last Post By: Mike Heidrick Yesterday, 9:42 PM Go to last post
    Tim Dennis

    How to get started with the project?

    Thread Starter: Tim Dennis

    Hi All, I was referred over to Sawmill Creek to get some info on the FP project. I've sent some emails and a PM but I'm not getting any response. Does anyone know who I can contact to get involved? I've sent some posts with addresses to order kits but I'm hesitant to do so without being...

    Last Post By: Keith Outten Yesterday, 4:49 PM Go to last post
  • Dan Hintz

    There is no available content written by Dan Hintz