Time for some levity

With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

How to bend wood like this - Outdoor furniture project

Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...

Is there a small, accurate table saw?

I need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...

cope and stick micro shaker?

has anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...

Drill w/guide or router?

Here's one I've been going over for the last 6 months. We have sliding pocket doors that separate our dining room and our family room. There are two of them 30 inches wide and they meet in the middle to form one 60 inch opening when open and a solid "wall" when closed. When they are open,...

Looking for feedback before I buy an Avid CNC

Good day all. I appreciate the time to read and give feedback. I think this is the right machine and price, but want feedback. The time has come. I need a CNC to stay competitive and I also just want to create in new ways. I have “non-buyers remorse” for stopping bidding on a beautiful 5x10...

Glaziers Points Sizes

I'll send the points out tomorrow. I should still have your address in my PM's.

Glaziers Points Sizes

Tom I purchase that tool, thanks for providing that link and help

Arts & crafts pole lamp from quarter sawn oak

I'm not sure why you'd need a locking miter for that. This is long grain adhesion...it will be insanely strong, even for a short lamp.

ISO Tormek T-8

Title says it all, looking for a used Tornek T-8 in good shape. Located in Indiana, will pay via PayPal.

New Workshop Questions

Nominal thickness differences are >25% between them. No brainer for me. Personally I'd go 24 gauge at least for the roof.

SC Pig-Picking