• Bill White

    There is no available content written by Bill White
  • Recent Polls

    Your favorite new production bench chisel (Votes: 84)

    1. Lie Nielsen (Votes: 34)

    2. Lee Valley PM-V11 (Votes: 23)

    3. Lee Valley O1 (Votes: 1)

    4. MHG (Votes: 2)

    5. Two Cherries Hirsch (Votes: 2)

    6. Stubai (Votes: 1)

    7. Pfeil (Votes: 3)

    8. Sorby (new production) (Votes: 1)

    9. Stanley sweetheart (new production) (Votes: 6)

    10. Ashley Iles (Votes: 11)

  • Recent Forum Posts

    Ira Matheny

    Suggested Wood Moisture Meter for shop

    For a number of years I have used a Delmhorst J-Lite. Very happy, except it was stolen. Purchased another just like it and still very happy.
    Ira

    Ira Matheny Today, 7:24 PM Go to last post
    Joe Wood

    Help Me With Snipe

    well we waxed the table, adjusted the outfeed pressure 2 turns or so, lowered the rollers, but what helped the most was holding the end of the timber

    Joe Wood Today, 7:23 PM Go to last post
    Roger Chandler

    Well, I finally did it.

    Congrats on the new G0766, Bill! Pics are always in order! Lots of great help and info on the Grizzly Green Monster Group [GGMG]. Feel free to join

    Roger Chandler Today, 7:16 PM Go to last post
    Brice Rogers

    Knockout bar

    Do you have to drill the entire length of the spindle or just the chuck end? If it is the entire length, give some thought on how you are going to keep

    Brice Rogers Today, 7:05 PM Go to last post
    mike klein

    Engravelab Version 8 Needed

    Anyone have version 8 of Engravelab they are wanting to get rid of. I have version 9.1 but a couple of the features in it are not working properly with

    mike klein Today, 6:52 PM Go to last post
  • Recent Blog Posts