• Rick Fisher

    There is no available content written by Rick Fisher
  • Recent Polls

    Your favorite new production bench chisel (Votes: 84)

    1. Lie Nielsen (Votes: 34)

    2. Lee Valley PM-V11 (Votes: 23)

    3. Lee Valley O1 (Votes: 1)

    4. MHG (Votes: 2)

    5. Two Cherries Hirsch (Votes: 2)

    6. Stubai (Votes: 1)

    7. Pfeil (Votes: 3)

    8. Sorby (new production) (Votes: 1)

    9. Stanley sweetheart (new production) (Votes: 6)

    10. Ashley Iles (Votes: 11)

  • Recent Forum Posts

    Matthew Slauson

    Delta 31-255x drum sander repair.

    John,I did what was essentially in your link,except I made a new 1/2" diameter driveshaft. In addition to that problem, there was also aproblem that

    Matthew Slauson Today, 2:10 PM Go to last post
    Jim Koepke

    Lie Nielsen Blades Not Staying Sharp

    Like everyone else you will see the road to sharpening nirvana is a long journey. What seemed sharp to me a few years ago now seems like a good starting

    Jim Koepke Today, 2:07 PM Go to last post
    Marvin Hasenak

    What tool is this

    I once worked in a shop that sold industrial equipment, one particular customer was a practical joker. When ever he ordered new equipment, the owner

    Marvin Hasenak Today, 2:01 PM Go to last post
    Van Huskey

    Woodmaster drum sanders would you buy again ?

    I keep a crepe block next to mine and clean the paper often. I think it was Sam Blasco that mentioned using silicon that had dried in the tube, I haven't

    Van Huskey Today, 2:00 PM Go to last post
    Prashun Patel

    Spray can shellac

    The 'spray the can upside down for a sec' after you finish each session tends to work ok to keep the nozzle cleaner.

    Prashun Patel Today, 1:59 PM Go to last post
  • Recent Blog Posts