• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Joe Flores

    WARNING concerning Access Used Lasers

    Thread Starter: Joe Flores

    Hello all just want to tell you about a problem I am having with Access Used Lasers. They sold my laser per an agreement we had. Received $6000.00 deposit. After they sold the laser they did not pay me the last $6000.00. Now they are not answering my phone calls. I trusted Robert now it looks like...

    Last Post By: Kev Williams Yesterday, 1:57 PM Go to last post
    Todd Burch

    Timber Frame Workshop (and house...)

    Thread Starter: Todd Burch

    So, this might turn out to be a long thread... long from a time-period standpoint, and long from a lot of posts. (and maybe long from my windedness too! ;) ) I want to build a timber frame shop and house. I can't afford hiring it out. The house I had quoted was $100K just for the frame...

    Last Post By: Todd Burch Yesterday, 11:59 AM Go to last post
    Moses Yoder


    Thread Starter: Moses Yoder

    I have no wish to fight, I would just like to see a logical discussion on this topic. The following posts were made in a thread about a book that was written concerning the Studley tool chest in the Neanderthal Haven forum. The Studley chest has always been an interest of mine since I first saw the...

    Last Post By: Shawn Pixley Yesterday, 9:07 PM Go to last post
    Jim Dwight

    Why serious Woodworkers need track saws

    Thread Starter: Jim Dwight

    I used to use a table saw with 60 inch rip capacity, a workbench at the right height for outfeed support, and a router table the right height for infeed support. I could cut up full sheets of plywood by myself. But the size of space required challenged my shop and it was sometimes difficult to...

    Last Post By: Peter Quinn Yesterday, 9:41 PM Go to last post
    Bryan Rocker

    4' LED shop light

    Thread Starter: Bryan Rocker

    This evening while at Sam's I came across a bright 4' ceiling light fixture, upon further inspection it was a 4200 lumen 5000k fixture complete for $35. I may have to go get me one or two of those.....The LED's were in a protective tube, would post the URL but it doesn't have any info yet.....I am...

    Last Post By: Alan Bienlein Yesterday, 8:34 PM Go to last post
    Jerry Hillenburg

    Powermatic 1150 VS Drill Press Rebuild. HELP

    Thread Starter: Jerry Hillenburg

    I bought a like new Powermatic 1150 VS serial #8615V167 in 1993 and it served me well until 2005 when the drive sheave assembly was damaged beyond repair because of a loose bolt. I patched it up and it runs, but I cannot adjust the speed and it is very noisy. It is not the most used machine in my...

    Last Post By: Kevin W Johnson Yesterday, 4:55 PM Go to last post
  • Steve Clardy

    There is no available content written by Steve Clardy