• Bill ThompsonNM

    There is no available content written by Bill ThompsonNM
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Doug Walls

    Leveling table saw side wings?

    That's another good point! I wire-wheeled & lightly sanded the machined mating surfaces, But the back (bolt head) side is not machined & just

    Doug Walls Today, 11:04 AM Go to last post
    Curt Harms

    Bluetooth adapter for cars, do you have one and does it work ??

    We have an Alpine box with bluetooth built in. It seems to work quite well. I have a Pioneer GPS with bluetooth and while it's usable the audio quality

    Curt Harms Today, 11:01 AM Go to last post
    Derek Cohen

    Lee Valley Veritas Round bottom spokeshave

    Hi Prashun

    Check the bevel angle. It may be too high and this could be limiting blade projection. It should be around 25 degrees.

    Derek Cohen Today, 10:54 AM Go to last post
    Floyd Mah

    New drill press - stock table - rough machine marks

    I bet most people will make a custom top for their drill press to facilitate clamping and supporting. They probably haven't seen the finish of the metal

    Floyd Mah Today, 10:50 AM Go to last post
    David Weaver

    Is it time for a Mac?

    I don't get spoofed emails from my bank. Why would that be any different with a mac or PC? I see a mac as the same type of penalty payment that someone

    David Weaver Today, 10:49 AM Go to last post
  • Recent Blog Posts