• Sections

  • Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Jim Koepke Today, 1:36 AM Go to last post
    Edward Weber

    Are your tools dangerous?

    Thread Starter: Edward Weber

    Do you consider tools as dangerous? https://www.popularmechanics.com/home/tools/how-to/g2394/10-workshop-tools-that-can-kill-you/ I came accross this article and it struck me, that I don't consider my tools as dangerous or not. To me it's just a tool. Sure, some tools can cause greater injury...

    Last Post By: Edward Weber Today, 2:41 PM Go to last post
    Joel Goodman

    MRI Question

    Thread Starter: Joel Goodman

    My doc tells me I need an neck MRI to diagnose some arm pain that may be starting in the neck. On the phone the MRI facility asked me if I had ever been involved with "metal grinding". Of course as a woodworker I've sharpened tools on a wheel, drilled holes in metal etc. I'm hoping to get more...

    Last Post By: Bill George Today, 4:53 PM Go to last post
    Alan Rutherford

    Point of Use Hot Water Heater Questions

    Thread Starter: Alan Rutherford

    Hot water travels about 60 feet from the tank to our upstairs bathroom and it takes too long to get there. I'm thinking about installing a point-of-use heater with a mini-tank but don't know if it will do what I want. Can I install a 2.5 gallon POU heater in the hot water supply to the bathroom and...

    Last Post By: Alex Kyle Today, 4:56 PM Go to last post
    Malcolm Schweizer

    Major upgrade- Grizzly 24” bandsaw has arrived

    Thread Starter: Malcolm Schweizer

    I will do a video once we get the 3-phase wired up, but here is how big the 24” 7.5hp Grizzly bandsaw is. No photos I found online really showed the true size. For anyone wondering if it will fit in the shop- it is 83.5” tall. The crate adds about 6” (4” pallet and 2” additional crate height.)....

    Last Post By: Curt Harms Today, 9:52 AM Go to last post
    David Zaret

    cope and stick micro shaker?

    Thread Starter: David Zaret

    has anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...

    Last Post By: Maurice Mcmurry Yesterday, 7:17 PM Go to last post

  • Ray Bersch

    There is no available content written by Ray Bersch