• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Jerome Stanek

    Glowforge release

    Thread Starter: Jerome Stanek

    I was wondering if Glowforge has sent out any units yet. I thought they were supposed to release the middle of December.

    Last Post By: Steve Morris Today, 5:12 AM Go to last post
    Mike Heidrick

    Pole Barn 40X64X16

    Thread Starter: Mike Heidrick

    Signed a contract yesterday with S&L Builders out of Indiana for a 40X64X16 Pole Barn with a 10X24 porch. Build date August 18, 2014. Plan to install Pex for raidant floor heat. Concrete slab 5" thick. Also doing 1.5" closed cell foam under the pad. Built on Laminated posts in ground. Will...

    Last Post By: Mike Heidrick Today, 12:14 AM Go to last post
    Eric Schubert

    My First Workbench Build - A Journal

    Thread Starter: Eric Schubert

    Welcome to my journal thread for my very first major build: a workbench! I plan to add photos and updates as I make progress on the bench build, which may or may not be frequently. It all depends on how it plays out. But, I'm hoping that it'll be a learning experience for both you and me, and...

    Last Post By: Eric Schubert Yesterday, 2:39 PM Go to last post
    Patrick Chase

    Ruler trick example

    Thread Starter: Patrick Chase

    This is a tangent from Stewie's "stone flattening" thread, particularly the assertion that ruler-tricking is used as a substitute for flattening the back of an iron. Here's an example of ruler-tricking done as Charlesworth recommends (a quickie snap of the iron from my L-N 8). Note the...

    Last Post By: Charles Guest Yesterday, 10:17 PM Go to last post
    Normand Leblanc

    Getting ready for the winter: Sharpening your ice scraper.

    Thread Starter: Normand Leblanc

    This post is for anyone living in cold climate and, whoever do not have to deal with snow and ice, see next post and please do not give your opinion on something you don't know. It's pretty technical so we'll keep this discussion for those concerned. For this difficult sharpening, I propose the...

    Last Post By: Malcolm McLeod Yesterday, 8:08 PM Go to last post
    Martin Wasner

    My new shop

    Thread Starter: Martin Wasner

    I've been in business 12 years. My first shop was 1600 sq/ft, I occupied it for almost six years. The current shop is 2500 sq/ft. As of a few days ago, I've been in here six years. When I first moved into the current space, I thought it would take a long time to fill it up. Turns out it only...

    Last Post By: Martin Wasner Yesterday, 7:43 PM Go to last post
  • Baxter Smith

    There is no available content written by Baxter Smith