• Mike Henderson

    There is no available content written by Mike Henderson
  • Recent Polls

    Your favorite new production bench chisel (Votes: 84)

    1. Lie Nielsen (Votes: 34)

    2. Lee Valley PM-V11 (Votes: 23)

    3. Lee Valley O1 (Votes: 1)

    4. MHG (Votes: 2)

    5. Two Cherries Hirsch (Votes: 2)

    6. Stubai (Votes: 1)

    7. Pfeil (Votes: 3)

    8. Sorby (new production) (Votes: 1)

    9. Stanley sweetheart (new production) (Votes: 6)

    10. Ashley Iles (Votes: 11)

  • Recent Forum Posts

    Bill Dufour

    My first PM purchases

    For the jointer a sheet of plywood to cover the entire chute area. then a HVAC register box and cut a hole in the plywood to match. Attach with supermagnets

    Bill Dufour Today, 10:58 AM Go to last post
    Malcolm McLeod

    Thicknesser electrics. SCM S3B

    Tom,
    I am still drawing blank on manuals, for both and the GV1 and the Breter, however, I got a few moments of quality time with your schematic:

    Malcolm McLeod Today, 10:58 AM Go to last post
    Bob Bouis

    Turning blank storage

    He wants to run electrical for welding and his table saw, planer, etc. But otherwise it's for storage. I couldn't convince him to move his whole shop

    Bob Bouis Today, 10:56 AM Go to last post
    Jim Belair

    Hollow auger use help

    OK thanks for the input. I don't own a bit extension but may try and rig up a reference point next to the chuck or the brace pad (or both).

    Jim Belair Today, 10:53 AM Go to last post
    John Lifer

    EZCAD2 Screen dimensions vs. Actual dimensions don't match.

    Section 10 of the 2.10 manual. And check your TC positions. Mine was ending a quarter to half MM to early. And took a bit of playing with it to get

    John Lifer Today, 10:52 AM Go to last post
  • Recent Blog Posts