• Jim Rimmer

    There is no available content written by Jim Rimmer
  • Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    Andy Lachman

    3/16" Dado Burning Red Oak

    Thanks
    I tried 1/4" the same thing happened
    The groove will be filled but is smoking really heavily
    Should I go with a rip

    Andy Lachman Today, 9:04 PM Go to last post
    Jim Andrew

    sliding table saw ?

    The small crosscut fence on my Hammer is pretty easy to install. I made some fixtures for the wall so the attachments are hanging on the wall beside the

    Jim Andrew Today, 9:03 PM Go to last post
    Jim Andrew

    Window Framing Question

    When I was a builder, retired in '01, I used the header as the top of the opening. If it was a double 2x12, all the headers were 2x12. Sometimes had

    Jim Andrew Today, 8:58 PM Go to last post
    Andy Lachman

    3/16" Dado Burning Red Oak

    Yes brand new blade
    I was going to edit going with the grain
    So I guess technically it is a groove not a dado

    Andy Lachman Today, 8:57 PM Go to last post
    Bill Melin

    Rusty iron

    So my new shop is built and my tools have all been moved from their last location ... so what is the best way to deal with the rust they have accumulated

    Bill Melin Today, 8:52 PM Go to last post
  • Recent Blog Posts