• Garrett Ellis

    There is no available content written by Garrett Ellis
  • Recent Polls

    Your favorite new production bench chisel (Votes: 88)

    1. Lie Nielsen (Votes: 36)

    2. Lee Valley PM-V11 (Votes: 23)

    3. Lee Valley O1 (Votes: 1)

    4. MHG (Votes: 3)

    5. Two Cherries Hirsch (Votes: 2)

    6. Stubai (Votes: 1)

    7. Pfeil (Votes: 4)

    8. Sorby (new production) (Votes: 1)

    9. Stanley sweetheart (new production) (Votes: 6)

    10. Ashley Iles (Votes: 11)

  • Recent Forum Posts

    Chris Hachet

    Owwm obsession

    Very, very nice...I have a 1973 Delta Unsiaw, a 1941-ish Walker turner 14 inch band saw, a Wards Power Kraft lathe, a Buffalo 18 Drill press, a Powermatic

    Chris Hachet Today, 11:01 AM Go to last post
    Greg Parrish

    Turning green/wet walnut

    All all good feedback so far. With regards to above, I did have some end grain and maybe the pith. Can't remember and not in front of it. But thinking

    Greg Parrish Today, 10:59 AM Go to last post
    lowell holmes

    Any Old Draftsmen out there?

    Are there any old piping designers out there?

    lowell holmes Today, 10:49 AM Go to last post
    Mike Delyster

    Owwm obsession

    I have a couple of restored Deltas, but I like the Canadian built stuff.
    Here are a couple of mine that are in the Vintage section at the Canadian

    Mike Delyster Today, 10:49 AM Go to last post
    Larry Edgerton

    Tips from a Shipwright -- Check this guy out!

    My kitchen in my own house has six different kinds of slides, leftovers from jobs long forgotten, so this I understand.

    Larry Edgerton Today, 10:44 AM Go to last post
  • Recent Blog Posts