• Sections

  • Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    James Jaragosky

    Rabbit owners

    Thread Starter: James Jaragosky

    Please introduce yourself. If you could also put what model machine you have, and how long you have had it That would really help. My purpose in creating this thread is so we can help support each other, Because as you all know by now, factory support for everyday problems is limited. And there...

    Last Post By: Dennis Watson Today, 9:36 AM Go to last post
    Russell Neyman

    Your Best Nifty Shop Tip?

    Thread Starter: Russell Neyman

    It's the small things that often make the biggest difference. I've found that the crafty veterans seem to know a little trick here or there that make turning better, safer, faster, or easier. So I'm throwing out a challenge: give us your best "nifty" and when this thread is done, it will make a...

    Last Post By: Rich Stewart Yesterday, 11:48 AM Go to last post
    Steve Voigt

    Sharpening technique--removing the wire edge

    Thread Starter: Steve Voigt

    Hi all, This post may portray me as embarrassingly stupid and inefficient, but whatever. Here goes. For the last 15 years, regardless of the sharpening media, I have used the following method: 1) hone a secondary bevel on a coarse stone until I can feel the wire edge on the back, all the way...

    Last Post By: george wilson Yesterday, 3:19 PM Go to last post
    Don Jeansonne

    cyclone selection-- Onieda, Grizzly, or Penn State

    Thread Starter: Don Jeansonne

    I have come the conclusion that I need to upgrade to a cyclone with 3hp min size. I am looking at Onieda V3000, Grizzly G0441, and Penn State 3.5hp. The cost differences are not that mush with Penn State being lowest. I would like to know people's opinions about the pros & cons of these suppliers....

    Last Post By: James White Today, 10:22 AM Go to last post
    Jeff Woodcock

    Laser Engraving True 8bit Shades of Grey

    Thread Starter: Jeff Woodcock

    Hi everyone, I'm new here and this is my first thread and post on this forum. I would like to introduce to everyone a new process me and my son developed to laser engrave true 8bit shades of grey using a 445nm laser diode. There is no dithering a image first, no pulsing or overlapping dots to...

    Last Post By: John Champlain Yesterday, 11:58 AM Go to last post
    Dave Cav

    Lie Nielsen new waterstones

    Thread Starter: Dave Cav

    If didn't have a good set of Shapton pro stones I'd be looking at these. The combo stones appear to be a pretty good deal. http://www.lie-nielsen.com/catalog.php?sku=2-OHISHII

    Last Post By: David Weaver Yesterday, 12:18 PM Go to last post

  • Dave Lehnert

    There is no available content written by Dave Lehnert