• Recent Polls

    What to use for mitre bar stock? (Votes: 74)

    1. Anything other than $40 worth of Incra mitre bars is not worthy of your crosscut sled. (Votes: 6)

    2. Not worth $40, but you really should take the time to drill/tap steel bars for your sled. (Votes: 13)

    3. Run what you brung, square the sled to the blade, shoot some brads, countersink, move on. (Votes: 41)

    4. You are over-thinking this in a big way. Nothing to see here, move along. (Votes: 11)

    5. Carrots and peas. (Votes: 3)

  • Recent Forum Posts

    scott vroom

    My new kitchen

    Fred, beautiful cabs...I love the straight grained QSRO and attention to detail. Overall a nice remodel! Thx for posting the pics and vid....nice to

    scott vroom Today, 1:06 PM Go to last post
    Jim Rimmer

    How much do you tip your oil change guy?

    I would prefer it be done that way. Many waiters/waitresses get stiffed on the tips by tightwads. And many restaurants now combine all tips and divide

    Jim Rimmer Today, 1:01 PM Go to last post
    Bob Rufener

    Woodworking Venues While Traveling to the UK and Scotland

    My wife and I went to Scotland a few years ago. Beautiful country. I don't know much about woodworking places of interest but Edinburgh is a beautiful

    Bob Rufener Today, 1:01 PM Go to last post
    Paul McGaha

    How much do you tip your oil change guy?

    Just my $.02 but I don't think it's usual to tip someone working on your car. I've never done it or seen it done.

    In a lot of cases you

    Paul McGaha Today, 1:00 PM Go to last post
    Zach Dillinger

    Grained chest over drawers

    Mel, I thought about that. My major reason for assuming it was supposed to be burl is the lack of red. But I didn't see a chemical composition report

    Zach Dillinger Today, 12:58 PM Go to last post
  • Recent Blog Posts