• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Patrick Chase

    Source for high-angle toothing plane?

    Thread Starter: Patrick Chase

    After Stewie's gentle prompting in another thread, I've gone off and read everything I could find on the topic, and realized that my exposure to toothing planes is grossly incomplete, limited as it is to toothed blades for low-angle BU planes. I'm therefore interested in acquiring a high-angle (80+...

    Last Post By: george wilson Yesterday, 7:56 PM Go to last post
    Mike Henderson

    Hot Hide Glue Question

    Thread Starter: Mike Henderson

    When I do a project such as a chest of drawers, I usually use half blind dovetails to attach the bottom to the sides. I'm attempting to learn more about hot hide glue and want to do a project using it. Note the word "hot" for the hide glue. I'm not looking to use liquid hide glue, I want to use...

    Last Post By: Leo Passant Yesterday, 10:34 PM Go to last post
    Keith Outten

    FreeStuff Drawing - Premium Woodturning Set

    Thread Starter: Keith Outten

    FreeStuff Drawing from Carter and Son Toolworks The name of the winner of this drawing will be announced on February 11th, 2016 Premium Woodturning Set Includes: 5/8" Bowl gouge: Incredibly strong and sharp, our 5/8" Bowl Gouge offers an enhanced bowl turning experience. Made of M42...

    Last Post By: kevin nee Yesterday, 10:17 PM Go to last post
    Stew Hagerty

    Veritas Shooting Plane Tolerance

    Thread Starter: Stew Hagerty

    Hey all... It's been quite a while since I posted. The last year or so hasn't been great. Anyway, that has absolutely nothing to do with this post. A couple years ago out in Iowa at Handworks I so a thing of beauty. It was the plastic prototype for a Veritas Shooting Plane. Now the Stanley...

    Last Post By: Hilton Ralphs Today, 2:09 AM Go to last post
    Ed Gibbons

    Ouch--Getting Saw Stop

    Thread Starter: Ed Gibbons

    Spent some time in the ER and ended up seeing a hand surgeon. Just nicked the tip of my finger. Didn't look pretty but prognosis is good. Surgeon said that most table saw injuries happen after years of operation. Rookies are more focused but experienced woodworkers become too comfortable. I fit...

    Last Post By: Tom Ewell Today, 9:18 AM Go to last post
    Glen Blanchard

    What happens when an air compressor tank rusts?

    Thread Starter: Glen Blanchard

    Let's say that I have an air compressor that I have not really treated with lots of TLC. Let's say that I've had it for about 15 years and have only drained the moisture inside the tank a few times. Now let's say that it's rusting inside. What eventually happens? Does the rust eventually eat...

    Last Post By: Keith Outten Yesterday, 2:23 PM Go to last post