• Chris Parks

    There is no available content written by Chris Parks
  • Recent Polls

    How do you pronounce "fascia"? (Votes: 50)

    1. FAH-sya (Votes: 4)

    2. FAH-see-ya (Votes: 5)

    3. FAY-sya (Votes: 39)

    4. FAY-see-ya (Votes: 2)

    5. What the heck is a fascia? (Votes: 0)

  • Recent Forum Posts

    M Toupin

    Cutting padlocks

    If it's just a run of the mill master padlock wrench it, they aren't hardened and break easily. Here's video, a couple 12" adjustable wrenches

    M Toupin Today, 6:50 PM Go to last post
    Mike Chance in Iowa

    It's Always the Stupid Things

    I had an instructor that always said "Never overlook the obvious." Half the kids in the class failed the "obvious" part of the final

    Mike Chance in Iowa Today, 6:48 PM Go to last post
    Bill Dufour

    Cutting padlocks

    A 3/8 drill should do it. You do not need to drill the entire cylinder out just disengage the lock at the back end. If you were able to be perfectly

    Bill Dufour Today, 6:42 PM Go to last post
    David Kumm

    Powermatic 64 Taiwan import???

    Wasn't the 64 their contractor " Artisan " series saw? PM imported a lots of machines in the 90s, including some of their industrial lines.

    David Kumm Today, 6:34 PM Go to last post
    lowell holmes

    Best wood for Mallets??

    I had a mallet that I liked, it was hard maple. Apparently, I lost it when Harvey came through. I bought it on line, but I don't remember where.

    lowell holmes Today, 6:33 PM Go to last post
  • Recent Blog Posts