• David Helm

    There is no available content written by David Helm
  • Recent Polls

    Your favorite new production bench chisel (Votes: 88)

    1. Lie Nielsen (Votes: 36)

    2. Lee Valley PM-V11 (Votes: 23)

    3. Lee Valley O1 (Votes: 1)

    4. MHG (Votes: 3)

    5. Two Cherries Hirsch (Votes: 2)

    6. Stubai (Votes: 1)

    7. Pfeil (Votes: 4)

    8. Sorby (new production) (Votes: 1)

    9. Stanley sweetheart (new production) (Votes: 6)

    10. Ashley Iles (Votes: 11)

  • Recent Forum Posts

    Reed Gray

    pricing wide rim bowls

    Hmm, I would have difficulty getting $100 for them here. If it is a more 'artistic' type show, then maybe. I never did well with artistic pieces, but

    Reed Gray Today, 9:49 AM Go to last post
    Bill Dufour

    Next TS setup from a portable contractors TS?

    If you had said CS I would have figured it out. If there was no ICS saw company I might have figured it out. I have only seen them called a cabinet

    Bill Dufour Today, 9:45 AM Go to last post
    Kevin Vasko

    Chisels and sharpening stone and...

    Thank you very much for the long and detailed responses (to everyone). I've been doing a lot of research for the past few days on this to figure out a

    Kevin Vasko Today, 9:45 AM Go to last post
    Robert Engel

    What's Up With Plywood???

    Ben is partly correct.

    Be aware even the pro lumber distributors (at least the ones around me) carry the Chinese and Ecuador plywood, usually

    Robert Engel Today, 9:41 AM Go to last post
    lowell holmes

    Block Plane Recommendation

    I have a 60 1/2. I like it but my most used block plane is my Veritas apron plane. It does live in my apron.

    lowell holmes Today, 9:40 AM Go to last post
  • Recent Blog Posts