• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Michael Pyron

    Chisels

    Thread Starter: Michael Pyron

    yep, mighty useful tools. I'm at a point in my life where I feel the need to upgrade from the Buck Brother's chisels I've been getting from Home Depot... the issue I see, is that quality chisels have wooden handles, and I use a 12 oz. hammer. I know my hammer VERY well, and since I'm an in...

    Last Post By: James Pallas Today, 2:19 PM Go to last post
    Mike Henderson

    Free SawStop Brake

    Thread Starter: Mike Henderson

    I was cutting a small piece of wood and before I knew it the blade was below the table and I had a small cut on my thumb. Don't even know exactly how everything happened. While the piece was small, I'd made the same cut many times before. Anyway, just a nick, bit of blood and a ruined...

    Last Post By: Ben Rivel Today, 1:35 PM Go to last post
    steven c newman

    Busy day today

    Thread Starter: steven c newman

    And now time for a few "Cold ones" First off, The Boss wanted a blind on the backdoor repaired with a new one.....New one needed those clips down at the bottom, to keep it from flopping around, used self-drilling drywall screws into the steel skin of the door...and had the driver tip drill into...

    Last Post By: steven c newman Today, 9:22 AM Go to last post
    Jeff Bartley

    Sharp chisels!

    Thread Starter: Jeff Bartley

    Sharp chisels yes! But not at the end, on the sides. I'm just wondering how many here have been cut up by the edges of their chisels? And does anyone purposely dull the side edges to prevent this? Jeff (with a slice on his index finger!)

    Last Post By: Stewie Simpson Today, 2:48 AM Go to last post
    Ben Rivel

    Building Your Own Oneida Realtime Filter Efficiency Gauge

    Thread Starter: Ben Rivel

    After studying the Oneida product page (LINK) and researching around the net I was able to figure out and put together the parts necessary to build my own Oneida Realtime Filter Efficiency Gauge. Its a very simple design and you can buy all the parts on your own for a lot cheaper than their kit. ...

    Last Post By: Randall J Cox Today, 10:48 AM Go to last post
    Peter Quinn

    Shaper wire brush head? Does such a thing exist?

    Thread Starter: Peter Quinn

    I'm looking for a wire brush head for a shaper, either metal or abrasive nylon, for texturing open grain wood such as oak or ash. I use a brushing machine at work similar to a drum sander, but it won't do edges of wide boards, and it won't do curves. I know they have sanding heads.....anyone...

    Last Post By: Joe Calhoon Yesterday, 8:08 PM Go to last post
  • Roland Martin

    There is no available content written by Roland Martin