• David Nelson1

    There is no available content written by David Nelson1
  • Recent Polls

    How do you pronounce "fascia"? (Votes: 50)

    1. FAH-sya (Votes: 4)

    2. FAH-see-ya (Votes: 5)

    3. FAY-sya (Votes: 39)

    4. FAY-see-ya (Votes: 2)

    5. What the heck is a fascia? (Votes: 0)

  • Recent Forum Posts

    Julie Moriarty

    Why not?

    When I was researching building the Offerman version of the router sled, I ran across a video of a guy who used a Makita planer. I own that same planer

    Julie Moriarty Today, 2:37 PM Go to last post
    Jim Becker

    Need advice on method to make 1/4+ molding

    Yea, along those lines, this could be done using not just a wider board, but would also require a thicker board. Cut the radius first (likely would require

    Jim Becker Today, 2:29 PM Go to last post
    David Kumm

    Required HP for a Phase Converter

    About 4200. Steep but if you can afford, it provides balanced power for all size motors. RPC are balanced for a limited output range. Usually good

    David Kumm Today, 2:26 PM Go to last post
    Jim Becker

    Resaw question

    My older MM16 only has 12" re-saw height. I personally haven't found it to be limiting other than a number of years ago, there was this one hunk

    Jim Becker Today, 2:26 PM Go to last post
    Jim Becker

    Noise Absorption - best approach?

    Yup...reflections. Anything that breaks them up is very helpful. It can be as simple as the exposed rough back of 1/4" hardboard pegboard...which

    Jim Becker Today, 2:21 PM Go to last post
  • Recent Blog Posts