• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Rodne Gold

    Chinese laser purchase/Shenui/Laserworks tips and tricks thread

    Thread Starter: Rodne Gold

    Considering a lot of us are going or have gone that direction , I thought it a good idea to combine our knowledge pool in one thread. So I have started one. Those of you that have already posted to other threads can perhaps repeat and consolidate the posts here or at least point to other posts on...

    Last Post By: Bert Kemp Yesterday, 10:54 PM Go to last post
    Matt McCoy

    Glowforge 3D Laser Printer

    Thread Starter: Matt McCoy

    Here's a New York Times article about the new laser Dan Shapiro and Glowforge are developing in Seattle. They call it a 3D laser printer and plan to sell it for $2,000 with friendly, but powerful, cloud-based software. "To cut costs, Glowforge has found ways to substitute sophisticated ...

    Last Post By: Scott Shepherd Today, 8:02 AM Go to last post
    Joe Flores

    WARNING concerning Access Used Lasers

    Thread Starter: Joe Flores

    Hello all just want to tell you about a problem I am having with Access Used Lasers. They sold my laser per an agreement we had. Received $6000.00 deposit. After they sold the laser they did not pay me the last $6000.00. Now they are not answering my phone calls. I trusted Robert now it looks like...

    Last Post By: Ed Coleman Yesterday, 1:28 PM Go to last post
    Rob Holcomb

    Home Depot Workers make me shake my head

    Thread Starter: Rob Holcomb

    Today, I put together my new band saw. It was wired for 220v and didn't come with a cord or plug. So off to Home Depot I go. I buy 10/3 wire and a plug and head back home. I wire the saw up and after finishing putting everything together, I want to fire up the saw to test it out. The plug I bought...

    Last Post By: Andy Fox Yesterday, 11:02 PM Go to last post
    Jim Dwight

    Why serious Woodworkers need track saws

    Thread Starter: Jim Dwight

    I used to use a table saw with 60 inch rip capacity, a workbench at the right height for outfeed support, and a router table the right height for infeed support. I could cut up full sheets of plywood by myself. But the size of space required challenged my shop and it was sometimes difficult to...

    Last Post By: Jim Dwight Today, 11:58 AM Go to last post
    Moses Yoder

    Communication

    Thread Starter: Moses Yoder

    I have no wish to fight, I would just like to see a logical discussion on this topic. The following posts were made in a thread about a book that was written concerning the Studley tool chest in the Neanderthal Haven forum. The Studley chest has always been an interest of mine since I first saw the...

    Last Post By: Moses Yoder Yesterday, 6:29 PM Go to last post
  • Mike Peace

    There is no available content written by Mike Peace