Seems like questions about Minimax bandsaws have been popping up and I wondered if there could be an opportunity to condense knowledge into and level-set some best-practices for setup? First, any contemporary Italian or large Austrian bandsaw ought be very straightforward to set up and get cutting...
Last Post By: STUART Robertson Today, 5:38 AMI had the high bid tonight on this Rockwell/Delta 28-350. I've been looking for and bidding on these for the last few years, and I was the back bidder a few times, but this one went for a very good price. My reserve bid was $600. It's possible that there's something terribly wrong with it, but...
Last Post By: Zachary Hoyt Yesterday, 10:39 AMI need a bumper sticker that says 'Nobody on board'. Tesla has opened up the 'self driving' app on newer Tesla's for a free 30 day trial. It is factory installed on all of them, they just don't turn it on unless you pay, which we didn't. All of a sudden there is an octogenarian who cannot...
Last Post By: Bill Dufour Today, 12:22 AMI drive a 2006 Toyota mostly on the highway. It has 90,000 miles with the original brakes. I don't hear any squealing on the brakes and they work fine. What do you think?
Last Post By: Larry Edgerton Today, 7:24 AMA lot of people - myself included - make it a policy to really avoid lending out tools. The list is a really short one of the people I will lend a tool to. What about - borrowing a tool?
Last Post By: Mike Henderson Yesterday, 5:51 PMSure - why not? (Votes: 8)
Never. If I needed something, I'd buy or rent it. (Votes: 8)
Maybe. Depends on the person and the tool. (Votes: 40)
We were down state last year and saw this on a number of occasions. We finally asked someone what the backstory was. It's a Jeep thing. I didn't understand.
Rob Luter Today, 8:33 AMI have gotten them before and I thank them for renewing it and I don't go to myPP account They give up real easy then
Jerome Stanek Today, 8:32 AMYou don't mention how much you need to build up the shaft. I've done this in the past using a plater. I had some small shafts that experienced fretting
Rob Luter Today, 8:28 AMLate to the party again. Been there, done that too, Jim. Nice save. The cabinet looks really good. FWIW, when I have mis-drilled, I plug the holes with
Grant Wilkinson Today, 8:26 AMI put a dial indicator on it yesterday and yes the blade is true. Amazing to me given the quick stop. The motor does start but the saw has no power.
Jack Frederick Today, 8:04 AM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jerry Thompson Yesterday, 7:24 PM