• richard poitras

    There is no available content written by richard poitras
  • Recent Polls

    Which vice for sawing (Votes: 30)

    1. Face vice (Votes: 13)

    2. Moxxon vice (Votes: 13)

    3. Other (Votes: 4)

  • Recent Forum Posts

    Keith Downing

    Quick question....

    Never heard of them. Google search didn't show up much either other than a couple rarely viewed youtube videos and one unhappy customer that had commented

    Keith Downing Today, 2:04 PM Go to last post
    AL Ursich

    Mirrors cracking

    Just a Wild AL Guess.... WAG... 4 passes at even lower power..... Your right... It's all about the heat.

    What do you expect from a Retired

    AL Ursich Today, 2:00 PM Go to last post
    Roger Chandler

    Carrying case for turning tools

    Section of 6 inch pvc pipe with end cap glued on one end and a clean out fitting glued to the other end, which has a screw out lid. Two things.....first,

    Roger Chandler Today, 1:56 PM Go to last post
    william watts

    hollow mortise chisels

    [QUOTE=Wes Ramsey;2561403]I
    First, how do you determine the proper size for a M&T? The only suggestion I've seen was that it should be about

    william watts Today, 1:54 PM Go to last post
    Blair Swing

    Dark Side of the Moon - Nearing Completion

    So haven't posted for a while, but been busy with other interests, light paintings, etc... however, have been working on this piece off and on for over

    Blair Swing Today, 1:51 PM Go to last post
  • Recent Blog Posts