• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Jack Clague

    Laser Engraver/Cutter - Questions and Decisions

    Thread Starter: Jack Clague

    Hi all, Hope everyone is doing well, I decided to sign up to the site as I have been a lurker for some time and found most of the threads here to be informative and helpful, recently I have decided to take my workshop to a higher level by looking to purchase a laser engraving and cutting...

    Last Post By: Jacob John Yesterday, 1:57 AM Go to last post
    Ron Sleeman

    Epilog vs Trotec

    Thread Starter: Ron Sleeman

    Okay boys & girls, I'm about to pull the trigger on a Epilog fusion 40 75watt or a Trotec speedy 400 80 watt. I have read about each of them on the forum. I guess what I'm looking at is the pro & cons on both of them from your point of view...lol I fine that they are both great machines. I will be...

    Last Post By: Keith Winter Yesterday, 11:29 PM Go to last post
    Anthony Whitesell

    Pondering acquiring a tracksaw

    Thread Starter: Anthony Whitesell

    I have begun to start pondering getting a tracksaw. Coincidentally, Fine Woodworking sent an email with some basic information and listed six manufacturers. Festool Dewalt Makita Triton Grizzly (and one other I can't read, but is red-orange in color). Does anyone have any experience with...

    Last Post By: Anthony Whitesell Yesterday, 11:08 PM Go to last post
    Julie Moriarty

    Conduit Bending 101

    Thread Starter: Julie Moriarty

    Since many here want to install conduit in their workshops, I thought I'd get a conduit bending workshop going here. The only damage you can do is too the pipe, and maybe your ego. ;) Of course, you need to have designed the system correctly. We can do that in another thread, if there's an...

    Last Post By: Peter Aeschliman Yesterday, 3:47 PM Go to last post
    Dave Lehnert

    Apron, Lee Valley or Duluth

    Thread Starter: Dave Lehnert

    Looked through the SMC search but a lot of links are now out dated. I narrowed my choice down to two. Duluth and Lee Valley. I was all set to order the Duluth but a little concerned with the side pockets are up a little high to get a tape measure out etc..... The Duluth...

    Last Post By: John T Barker Yesterday, 2:36 AM Go to last post
    John T Barker

    Shop air cleaner

    Thread Starter: John T Barker

    I'm looking to build or buy an air cleaner for my shop. I notice some build videos on youtube use attic air fans and the like. Anyone have any input on good choices/bad choices on this? They seem to pull more than enough cfm's. I'm trying to keep the costs down so I don't want to be over $75...

    Last Post By: Wade Lippman Yesterday, 9:21 AM Go to last post
  • Don Orr

    There is no available content written by Don Orr