• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Roger Chandler

    G0766 ... they're on their way!!!

    Thread Starter: Roger Chandler

    :D Just got word from CS @ Grizzly that the G0766 lathes have left the factory and are in fact "en route" and the expected delivery date for my unit is now ......get this, a week earlier May 15th! :) Now, I know there are some others who were expecting to have it shipped on May 22nd as...

    Last Post By: Dennis Collier Yesterday, 5:43 PM Go to last post
    Matt McCoy

    Glowforge 3D Laser Printer

    Thread Starter: Matt McCoy

    Here's a New York Times article about the new laser Dan Shapiro and Glowforge are developing in Seattle. They call it a 3D laser printer and plan to sell it for $2,000 with friendly, but powerful, cloud-based software. "To cut costs, Glowforge has found ways to substitute sophisticated ...

    Last Post By: Bert Kemp Yesterday, 4:16 PM Go to last post
    Joe Flores

    WARNING concerning Access Used Lasers

    Thread Starter: Joe Flores

    Hello all just want to tell you about a problem I am having with Access Used Lasers. They sold my laser per an agreement we had. Received $6000.00 deposit. After they sold the laser they did not pay me the last $6000.00. Now they are not answering my phone calls. I trusted Robert now it looks like...

    Last Post By: Scott Shepherd Today, 8:19 AM Go to last post
    Rob Holcomb

    Home Depot Workers make me shake my head

    Thread Starter: Rob Holcomb

    Today, I put together my new band saw. It was wired for 220v and didn't come with a cord or plug. So off to Home Depot I go. I buy 10/3 wire and a plug and head back home. I wire the saw up and after finishing putting everything together, I want to fire up the saw to test it out. The plug I bought...

    Last Post By: Ryan Mooney Today, 1:15 PM Go to last post
    Jim Underwood

    Jet 1642 Motor gone bad

    Thread Starter: Jim Underwood

    Welp. It finally happened. Sometime last year I began to hear a noise in the motor of my Jet EVS 1642. Of course it was just out of warranty. I bought it May of 2009 and started realizing the noise sometime last fall or so... Well Saturday I was in the shop turning some coffee table legs and the...

    Last Post By: Joe Kaufman Yesterday, 5:37 PM Go to last post
    Todd Burch

    Timber Frame Workshop (and house...)

    Thread Starter: Todd Burch

    So, this might turn out to be a long thread... long from a time-period standpoint, and long from a lot of posts. (and maybe long from my windedness too! ;) ) I want to build a timber frame shop and house. I can't afford hiring it out. The house I had quoted was $100K just for the frame...

    Last Post By: Jim Becker Today, 10:37 AM Go to last post
  • Charles Bjorgen

    There is no available content written by Charles Bjorgen