• Peter Lavik

    There is no available content written by Peter Lavik
  • Recent Polls

    Your favorite new production bench chisel (Votes: 84)

    1. Lie Nielsen (Votes: 34)

    2. Lee Valley PM-V11 (Votes: 23)

    3. Lee Valley O1 (Votes: 1)

    4. MHG (Votes: 2)

    5. Two Cherries Hirsch (Votes: 2)

    6. Stubai (Votes: 1)

    7. Pfeil (Votes: 3)

    8. Sorby (new production) (Votes: 1)

    9. Stanley sweetheart (new production) (Votes: 6)

    10. Ashley Iles (Votes: 11)

  • Recent Forum Posts

    Stew Denton

    Interesting Article in FWW on 18th Century woodworking

    Andy,

    Thanks, very interesting read.

    The comment about shop lighting was interesting. He mentioned that natural lighting

    Stew Denton Today, 10:40 PM Go to last post
    Leo Van Der Loo

    New Laguna lathe

    To add to John Keetonís reply which I do totally agree with, the groove on the spindle is to have the set screws go down into, and hold the chuck from

    Leo Van Der Loo Today, 10:39 PM Go to last post
    Mark Carlson

    Cutting Board Finish

    I use osmo top oil and howards mineral oil wax. Both look good. For friends I use howards and for personal use or family I use osmo. Its just easier

    Mark Carlson Today, 10:39 PM Go to last post
    Peter Froh

    Dust Collectors CNC Oh my

    Depending on the size of your CNC, maybe consider making an enclosure for your CNC and hook the dust collection up to that enclosure.

    Peter Froh Today, 10:34 PM Go to last post
    Leo Van Der Loo

    Loose belt or stall "management"??

    Thanks John, about the stalling of your lathe, that is where the shortcomings of a VFD comes into play, with the slower speed needed for very large heavy

    Leo Van Der Loo Today, 10:27 PM Go to last post
  • Recent Blog Posts